Difference between revisions of "I2C DAC"

From BitWizard Wiki
Jump to navigation Jump to search
(Created page with "Set a voltage: sudo i2cset -y 0 0x60 0x40 0xff 0xf0 i ^^ ^ < Voltage bits")
 
 
(12 intermediate revisions by 3 users not shown)
Line 1: Line 1:
= General info =
Based on the MCP4726 chip from Microchip.<br>
http://ww1.microchip.com/downloads/en/DeviceDoc/22272C.pdf <br>
<br>
I2C address:<br>
1100 000 and 1100 001 '''OR'''<br>
1100 010 and 1100 011<br>
You can order both versions. The addresses of your board can be found on the bottom side.

= Physical dimensions =
* Board outline: 25x25mm
* Mounting hole diameter: 3mm
* Mounting hole pitch: 19x19mm (3mm from board edge)

= Using the board =
Set a voltage:
Set a voltage:
sudo i2cset -y 0 0x60 0x40 0xff 0xf0 i
sudo i2cset -y 1 0x60 0x40 0xff 0xf0 i
^^ ^ < Voltage bits
^^ ^ < Voltage bits

explanation of the arguments:
-y don't ask confirmation
1 number of the I2C bus (0 on older raspberry pi's)
0x60 address of the DAC, use 0x61 (or 0x62 and 0x63) for the other DAC.
0x40 configuration: normal.
0xff high 8 bits of the value
0xf0 lower four bits of the value (in the high nibble)

Latest revision as of 12:08, 11 November 2015

General info

Based on the MCP4726 chip from Microchip.
http://ww1.microchip.com/downloads/en/DeviceDoc/22272C.pdf

I2C address:
1100 000 and 1100 001 OR
1100 010 and 1100 011
You can order both versions. The addresses of your board can be found on the bottom side.

Physical dimensions

  • Board outline: 25x25mm
  • Mounting hole diameter: 3mm
  • Mounting hole pitch: 19x19mm (3mm from board edge)

Using the board

Set a voltage:

sudo i2cset -y 1 0x60 0x40 0xff 0xf0 i
                             ^^   ^     < Voltage bits

explanation of the arguments:

-y    don't ask confirmation
1     number of the I2C bus (0 on older raspberry pi's)
0x60  address of the DAC, use 0x61 (or 0x62 and 0x63) for the other DAC. 
0x40  configuration: normal. 
0xff  high 8 bits of the value
0xf0  lower four bits of the value (in the high nibble)